![Biohazard-[SF]-](/data/avatars/m/7/7176.jpg?1394658493){kind=avatar}
Biohazard-[SF]-
Rox Powah
Hey,
I was wondering which of these bearings are best for high rpm?
I was wondering which of these bearings are best for high rpm?
C3 vs. C4 Bearings?
- Thread starter Biohazard-[SF]-
- Start date
The "C" rating stands for the clearance between the rings and rollers of the bearing. The greater the temperature variations the higher the C rating would be needed. C3 or C4 won't make much difference for a high rpm engine. However C4 would be preferable for a high-load engine.
Just stick to a known brand and everything will be fine (SKF, NSK,... )
Just stick to a known brand and everything will be fine (SKF, NSK,... )
Biohazard-[SF]-
Rox Powah
well a friend of mine said that the C4 make alot of noise?
And i will buy the MK Prorace kit (SKF C4) if we can find out more about noise...
And i will buy the MK Prorace kit (SKF C4) if we can find out more about noise...
Biohazard-[SF]-
Rox Powah
But the guy sed the C4 make as much noise as the exhaust :S
SKF C3 bearings are good up to 18000 RPM, so I think C3 is good. C4 bearings are made for very high temperature (they have bigger clearance) so they are good for air cooled motors cause they can overheat, but the LC motors are not operate at this high temperature, C4 not only needless, but if you use it for only warm (and not extremly hot) motor then it will be flap and it's not good for the other parts!
Biohazard-[SF]-
Rox Powah
Browni would u recormend i get C4? I will be running in 50/60 degrees weather... Spain... So thats already fairly warm...
The thing is, if i want C3 i have to special order, MK have a ready packed C4 with everything seals n that... Which would u recormend me? Will be running Polini Evo2 LC 12mm
The thing is, if i want C3 i have to special order, MK have a ready packed C4 with everything seals n that... Which would u recormend me? Will be running Polini Evo2 LC 12mm
