tiba_karotsu
OVERREV TUNING
what he means is that those cilinder studs & nuts that you use aren't the best quality.
Those threadends you have to mount your cilinder arent from good quality iron.
:+ indeed thats very nice dragbike you ot there...
just wanted to ask you about your E.T
on what distance is the running time measured?
660ft that's equal to 1/8mile or less?
im from PR and i have drag scooters
that run on 7.2 seconds and the fastest one that runs 7.19 @ 90MPH
on a 1/8mile that is 660feet
that's the fastest one in Puerto Rico....
oooh and mine are 4stroke (GY6 engines) Vento SCooters
and that's running on NOS
but i got another scooter that doesn't use NOS
and it is All-MOTOR and its the fastest alcohol fueled scooter in PR
and it runs 7.33 on 1/8mile @ 88MPH
the E.T was messured on 150 meters...1/8mile are 202meters...it is a little bit fewer...
THANX A LOT MY FRIEND!
BUT IS IT ALWAYS THAT YOU RUN ONLY 150meters?
so if i have one that runs on 1/8mile
7.19 @ 90.90MPH
what time can it do in 150meters?
i know that it would put like 88MPH or so'
but it can touch the 6.??seconds?
and an 180cc all motor engine
that hits 7.33 on the 1/8mile
it could run 6.?? in the 150meters too!
i would like to compete in a drag race over there
with my bikes that are 4-stroke
against the 2-strokes in there...