S6R squish?

[Spidy]

Hi mates!
I have a doubt on what squish i should set up for mine S6R cylinder, because i ain't got no manual, so if anybody has a guess i aprecciated. BTW how many degrees can i delay my stock ignition? Thanks for helping me out and sory for bad english

 

[Rage]

Think it's about 0.7

 

[Big B NRG]

The S6R cylinder should be around 0,5mm for LC and 0,6 mm for AC.

You can have a few degrees of pre ignition with your stock ignition. Not much more, because the curve isn't suitable for that.

 

[Spidy]

Ok, thanks for the help

 

[Spidy]

I've seen in other post (MHR-R Squish) that a low squish with low octane fuel leads to a shorter cylinder life time. I set the squish to 0.59 and use 95octane fuel, is this to hard for daily use?i want this cylinder to long a reasonable time, lbetween 5000 and 10.000km without having much problems,so if i start using 98octane fuel can i keep de 0.59squish or is better to raise it? thanks

 

[Big B NRG]

Use 98 octane and your cylinder will be fine

More important is to use good oil.

 

[Spidy]

I'm using Castrol R2, and i'll change to motul 800, and for now i'll keep using 95 octane gas, i'll change after a while to 98 (i'm in break in yet), but i think there's no much problem. Thanks