I have a malossi overrange pulley with a bad ball bearing. How do I get the snap ring out that holds it in place? I have the new replacement parts. I just can't find snap ring pliers long enough to reach down in the hole to take it out so I can replace the bearing. Any ideas?
Replacing overrange bearing.
- Thread starter DRXRACING
- Start date
You'll make it eventually. I think i used two spikes or i might even hammered it out. until the ring broke and got bent this way much easier to pull out.
Then just be careful installing the new bearing. I installed it and i think it broke during the installation cause it was as bad as the old one when it was fitted
!//Daniel
Similar threads
