This is a mobile optimized page that loads fast, if you want to load the real page, click this text.

Port Matching Question

M

mewbie

New Member
Hi, anyone here could give me an opinion with my project.

Basically did a portmatch to my cylinder kit and I was kinda worried about this part here being too thin. Would this possibly cause a leak or is it ok to run this.

Thanks a
 

Attachments

  • 20240730_234829.jpg
    152 KB · Views: 16
I dont have a lot of experience with 2 stroke, but is it the transfer port for the intake, so I think it is acceptable

If you not like it, you can use some liquid metal (2 component) to fill up the gap
 
it's_A_Lex said:
I dont have a lot of experience with 2 stroke, but is it the transfer port for the intake, so I think it is acceptable

If you not like it, you can use some liquid metal (2 component) to fill up the gap
Click to expand...
Yes its a two stroke, and yes it is the transfers on the case. I'll maybe try to put some epoxy onto it to thicken the sealing surface.

I guess im a bit anxious and OC about this. Thanks bro
 
does this surface require a ("paper" gasket? if so, you'd have to adapt that too and you would have very little material left to seal.. but i'd test it before i'd put epoxy there, with the chance of coming loose and breaking more than a blown gasket would, i guess..
 
It will be mated with a aluminum baseplate and gasket, i did however lay on some epoxy outside the skirt just to have a bit of sealing surface
 
You must log in or register to reply here.

Similar threads

O
Port timing
Replies
5
Views
2K
ottoman
O
D
MK sp kit port timing
Replies
2
Views
1K
DRXRACING
D
B
bridged exhaust port problems
2
Replies
25
Views
4K
manic
7t minarelli port timings?
Replies
1
Views
1K
hac
D
Port timings Metrakit pro race..MINA. 47.6
Replies
15
Views
6K
darookie
D