Most powerfull pipe on mhr cross minarelli?!

blaze02

Well-Known Member
Hello
I wanted to know which pipe is the strongest one on the malossi mhr cross (85mm rod) tuned cilinder for horiz. minarelli motors is!

Which is the strongest of this group:
Mhr Speed pipe
Krd f1
Tjt f1
yasuni c20
Hebo rII Piaggio fitted on minarelli
Mhr Speed 2000 Piaggio fitted on minarelli

And which is the strongest of this group (handmade pipes):
Vtm
Is tuning
(does any body of you know stronger ones?)

And at last, whisch is the most strongest pipe of all of them!
 
Advertisement - register to remove this

It depends to much on how your cilinder is tuned, but the yasuni c20 will give you very nice results.

Krd and Tjt aren't well tested yet, so maybe someone else can give more information.
 
Difficult question...
Depens on you're whole setup / finetuning.

Of the hm's , i think the vtm is the best one , but that's only because i never heard anyone about the is tuning pipe , etc

Edit :

The c20 will work fine in general.
 
Hole setup:

Mhr Cross tuned ( you can compare it with koopmans stage 4/5)
Mhr team krukas (85mm rod)
Mikuni TM 28
Overrange
Delta clutch or Hebo ``R`` raceclutch
wing bell
carters tuned (you can compare with koopmans stage 2/3)
malossi binnenrotor (don't know the english word :/ )
and the small things u know of the mhr series!
 
If u had a good Cross cil. then there is very less u can tune about it. The timing is already very extreme.

I can advise you to use a C20 exhaust.
Maybe a KRD but certainly not a Team exhaust.
A piaggio pipe isn't a nice choose i thnk. Becaue these exhaust are calculated on the exhaustport lengt of an piaggio cilinder , which is shorter then a minarelli.

My experiences with the C20 on a MHR Cross are outstanding.
Huge bottem and high end power.
My machine was set for 14k rpm
 
VTM.......

-:-



Originally posted by blaze02
Hello
I wanted to know which pipe is the strongest one on the malossi mhr cross (85mm rod) tuned cilinder for horiz. minarelli motors is!

Which is the strongest of this group:
Mhr Speed pipe
Krd f1
Tjt f1
yasuni c20
Hebo rII Piaggio fitted on minarelli
Mhr Speed 2000 Piaggio fitted on minarelli

And which is the strongest of this group (handmade pipes):
Vtm
Is tuning
(does any body of you know stronger ones?)

And at last, whisch is the most strongest pipe of all of them!
 
Originally posted by Folkert@MinaRally
Compare stage 4/5? A stage 4/5 what? Evo, Mhr, Airsel, Corsa, ..?

Inner rotor is the english word for "binnerotor" yes.


Lees nog eens goed opwat je quote dan weet je het...
 
hehehe, you're bigtime (rich) if you can afford VTM custom pipe. well some of us can only dream of getting a VTM. even if i had the $$$ it's still impossible to get one until Valentino makes another (limited) production run.
 
ey?!
ik ga ook Cross halen en alles flink tunen, maar ben er ook nog niet uit welke uitlaat....

welke heb jij nu??
(mijn voorkeur ligt bij tjt f1)
 
ALs je nou eens leest en verde rop t forum kijkt dan zie je dat er niet veel aan de cross te tunen valt en dat de TJT pijp niet geschikt is
 
how good is TJT F1 uitlaat? anybody care to give some info? i can get one thru a friend who's a TJT representative in Asia so any feedback is greatly appreciated.
 
Back
Top