Setting Pwk Up

[Alex_ice]

i really stuck on how i should set up my stage 6 pwk 24mm

i want to know needle height info, like which is leaner/richer up down/.et.c

also how do you get the air fuel screw right? how do u test for that?

how do u know which slow jet to try?

test the power jet? or should i block ot off

ive got the main jet right and it idles well

i wont go any less than full thottle or its boggs out till u wack the thottle back open, towns are nightmares

please help thanks

 

[Eoin70]

when the needle is down farthest its at the leanest becuase its now restricting the main jet and needle jet
when the needle is at its highest position its at the richest
of course this logic is reversed for the clip
low clip = high needle

 

[Alex_ice]

wot about the air fuel screw? slow jets and power jet?

 

[Alex_ice]

sum 1 help me out
to set the air/fuel screw do you just set it on idle and twist the screw till it revs highest then reset the idle?
how would i know if i needed a bigger/smaller slow jet?.

thankz